On 10/14/2025 6:21 PM, Dmitry Baryshkov wrote:
> On Tue, Oct 14, 2025 at 05:42:12PM +0800, Xiangxu Yin via B4 Relay wrote:
>> From: Xiangxu Yin <[email protected]>
>>
>> Add DP connector node and configure MDSS DisplayPort controller for
>> QCS615 Ride platform. Include lane mapping and PHY supply settings
>> to support DP output.
>>
>> Signed-off-by: Xiangxu Yin <[email protected]>
>> ---
>> arch/arm64/boot/dts/qcom/qcs615-ride.dts | 31
>> +++++++++++++++++++++++++++++++
>> 1 file changed, 31 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
>> b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
>> index
>> 9ac1dd3483b56f9d1652f8a38f62d759efa92b6a..0b8bcabdd90a0820b1f9c85e43b78e40eb8a9a38
>> 100644
>> --- a/arch/arm64/boot/dts/qcom/qcs615-ride.dts
>> +++ b/arch/arm64/boot/dts/qcom/qcs615-ride.dts
>> @@ -39,6 +39,20 @@ xo_board_clk: xo-board-clk {
>> };
>> };
>>
>> + dp0-connector {
>> + compatible = "dp-connector";
>> + label = "DP0";
>> + type = "mini";
>> +
>> + hpd-gpios = <&io_expander 8 GPIO_ACTIVE_HIGH>;
> Not the gpio102/ 103 / 104? Interesting.
Yes, on this platform the DP HPD signal is controlled by the pin controller
on the video-out sub-board, not by the TLMM on the SoC.
>> +
>> + port {
>> + dp0_connector_in: endpoint {
>> + remote-endpoint = <&mdss_dp0_out>;
>> + };
>> + };
>> + };
>> +
>> dp-dsi0-connector {
>> compatible = "dp-connector";
>> label = "DSI0";
>> @@ -423,6 +437,16 @@ &mdss {
>> status = "okay";
>> };
>>
>> +&mdss_dp0 {
>> + status = "okay";
>> +};
>> +
>> +&mdss_dp0_out {
>> + data-lanes = <3 2 0 1>;
> It's not a board peculiarity. All QCS615 / SM6150 devices are affected
> by this twist. Please move this to the SoC DT file.
Ok.
>> + link-frequencies = /bits/ 64 <1620000000 2700000000 5400000000>;
>> + remote-endpoint = <&dp0_connector_in>;
>> +};
>> +
>> &mdss_dsi0 {
>> vdda-supply = <&vreg_l11a>;
>> status = "okay";
>> @@ -623,6 +647,13 @@ &usb_qmpphy {
>> status = "okay";
>> };
>>
>> +&usb_qmpphy_2 {
>> + vdda-phy-supply = <&vreg_l5a>;
>> + vdda-pll-supply = <&vreg_l12a>;
>> +
>> + status = "okay";
>> +};
>> +
>> &usb_1 {
>> status = "okay";
>> };
>>
>> --
>> 2.34.1
>>
>>
