On 27/10/2025 17:26, Svyatoslav Ryhel wrote:
> пн, 27 жовт. 2025 р. о 18:08 Hans Verkuil <[email protected]> пише:
>>
>> Hi Svyatoslav,
>>
>> On 22/10/2025 16:20, Svyatoslav Ryhel wrote:
>>> Add support for MIPI CSI device found in Tegra20 and Tegra30 SoC along
>>> with a set of changes required for that.
>>
>> Other than patch 06/23 that looked iffy (although the original code was iffy
>> as
>> already), for which I posted a review, this series looks almost ready.
>
> 06/23 addresses issue I have encountered while testing with mt9m114 I
> will add detailed explanation later in the 06/23 commit discussion.
>
>>
>> Should the clk patches be merged together with the media patches? Or can
>> those
>> go in via the clk subsystem? If it is the latter, then I'll need an Acked-by
>> from the
>> clk subsystem maintainer.
>>
>
> I suppose this should be discussed between staging and clk subsystem
> maintainers I am fine with any conclusion.
>
>> Regarding the bindings: all except 21/23 are Acked.
>
> Maybe you did not notice, but 21/23 has reviewed-by from Rob Herring.
Ah yes, Rob replied. Good.
>
>>
>> I have one question regarding testing: in the past I tested this driver with
>> a
>> Jetson TX1 devkit and a camera sensor. One of the main reasons this driver
>> is still
>> in staging is that I never got that to work reliably: after 10-30 minutes it
>> would
>> lose sync and streaming would stop.
>>
>> Unfortunately I never had the time to dig deeper into that.
>>
>> So have you tested this with a camera sensor? And if so, does it stream
>> reliably?
>> I.e. just let it stream for 24 hours and see if that works.
>>
>> If it is reliable for you, then I think this driver should be moved to
>> drivers/media.
>
> Streaming works but I did not tested for such prolonged periods of
> time. Scope of this patchset is bringing CSI support for
> Tegra20/Tegra30, extended testing and move to media can be done in
> followup.
I'd really appreciate it if you can do a duration test. Perhaps start streaming
on
Friday and let it run for the weekend?
Regards,
Hans
>
>>
>> Regards,
>>
>> Hans
>>
>>>
>>> ---
>>> Changes in v2:
>>> - vi_sensor gated through csus
>>> - TEGRA30_CLK_CLK_MAX moved to clk-tegra30
>>> - adjusted commit titles and messages
>>> - clk_register_clkdev dropped from pad clock registration
>>> - removed tegra30-vi/vip and used tegra20 fallback
>>> - added separate csi schema for tegra20-csi and tegra30-csi
>>> - fixet number of VI channels
>>> - adjusted tegra_vi_out naming
>>> - fixed yuv_input_format to main_input_format
>>> - MIPI calibration refsctored for Tegra114+ and added support for
>>> pre-Tegra114 to use CSI as a MIPI calibration device
>>> - switched ENOMEM to EBUSY
>>> - added check into tegra_channel_get_remote_csi_subdev
>>> - moved avdd-dsi-csi-supply into CSI
>>> - next_fs_sp_idx > next_fs_sp_value
>>> - removed host1x_syncpt_incr from framecounted syncpoint
>>> - csi subdev request moved before frame cycle
>>>
>>> Changes in v3:
>>> - tegra20 and tegra30 csi schema merged
>>> - removed unneeded properties and requirements from schema
>>> - improved vendor specific properties description
>>> - added tegra20 csus parent mux
>>> - improved commit descriptions
>>> - redesigned MIPI-calibration to expose less SoC related data into header
>>> - commit "staging: media: tegra-video: csi: add support for SoCs with
>>> integrated
>>> MIPI calibration" dropped as unneeded
>>> - improved tegra_channel_get_remote_device_subdev logic
>>> - avdd-dsi-csi-supply moved from vi to csi for p2597 and p3450-0000
>>> - software syncpoint counters switched to direct reading
>>> - adjusted planar formats offset calculation
>>>
>>> Changes in v4:
>>> - removed ifdefs from tegra_mipi_driver
>>> - document Tegra132 MIPI calibration device
>>> - switched to use BIT macro in tegra114-mipi
>>> - pinctrl changes moved to a separate patch
>>> - ERESTARTSYS workaround preserved for now
>>> - tegra_mipi_add_provider replaced with devm_tegra_mipi_add_provider
>>> - reworked bytesperline and sizeimage calculaion
>>>
>>> Changes in v5:
>>> - dropped patch 1/24 of v4 since it was picked to pinctrl tree
>>> - added reasoning for tegra132 comaptible into commit desctiption
>>> - moved clocks into common section in tegra20-csi schema
>>> - added note regarding ERESTARTSYS
>>> ---
>>>
>>> Svyatoslav Ryhel (23):
>>> clk: tegra: set CSUS as vi_sensor's gate for Tegra20, Tegra30 and
>>> Tegra114
>>> dt-bindings: clock: tegra30: Add IDs for CSI pad clocks
>>> clk: tegra30: add CSI pad clock gates
>>> dt-bindings: display: tegra: document Tegra30 VI and VIP
>>> staging: media: tegra-video: expand VI and VIP support to Tegra30
>>> staging: media: tegra-video: vi: adjust get_selection op check
>>> staging: media: tegra-video: vi: add flip controls only if no source
>>> controls are provided
>>> staging: media: tegra-video: csi: move CSI helpers to header
>>> gpu: host1x: convert MIPI to use operation function pointers
>>> dt-bindings: display: tegra: document Tegra132 MIPI calibration device
>>> staging: media: tegra-video: vi: improve logic of source requesting
>>> staging: media: tegra-video: csi: move avdd-dsi-csi-supply from VI to
>>> CSI
>>> arm64: tegra: move avdd-dsi-csi-supply into CSI node
>>> staging: media: tegra-video: tegra20: set correct maximum width and
>>> height
>>> staging: media: tegra-video: tegra20: add support for second output of
>>> VI
>>> staging: media: tegra-video: tegra20: adjust format align calculations
>>> staging: media: tegra-video: tegra20: set VI HW revision
>>> staging: media: tegra-video: tegra20: increase maximum VI clock
>>> frequency
>>> staging: media: tegra-video: tegra20: expand format support with
>>> RAW8/10 and YUV422/YUV420p 1X16
>>> staging: media: tegra-video: tegra20: adjust luma buffer stride
>>> dt-bindings: display: tegra: document Tegra20 and Tegra30 CSI
>>> ARM: tegra: add CSI nodes for Tegra20 and Tegra30
>>> staging: media: tegra-video: add CSI support for Tegra20 and Tegra30
>>>
>>> .../display/tegra/nvidia,tegra114-mipi.yaml | 1 +
>>> .../display/tegra/nvidia,tegra20-csi.yaml | 138 +++
>>> .../display/tegra/nvidia,tegra20-vi.yaml | 19 +-
>>> .../display/tegra/nvidia,tegra20-vip.yaml | 9 +-
>>> arch/arm/boot/dts/nvidia/tegra20.dtsi | 19 +-
>>> arch/arm/boot/dts/nvidia/tegra30.dtsi | 24 +-
>>> .../arm64/boot/dts/nvidia/tegra210-p2597.dtsi | 4 +-
>>> .../boot/dts/nvidia/tegra210-p3450-0000.dts | 4 +-
>>> drivers/clk/tegra/clk-tegra114.c | 7 +-
>>> drivers/clk/tegra/clk-tegra20.c | 20 +-
>>> drivers/clk/tegra/clk-tegra30.c | 21 +-
>>> drivers/gpu/drm/tegra/dsi.c | 1 +
>>> drivers/gpu/host1x/Makefile | 1 +
>>> drivers/gpu/host1x/mipi.c | 525 ++---------
>>> drivers/gpu/host1x/tegra114-mipi.c | 483 +++++++++++
>>> drivers/staging/media/tegra-video/Makefile | 1 +
>>> drivers/staging/media/tegra-video/csi.c | 70 +-
>>> drivers/staging/media/tegra-video/csi.h | 16 +
>>> drivers/staging/media/tegra-video/tegra20.c | 820 +++++++++++++++---
>>> drivers/staging/media/tegra-video/vi.c | 56 +-
>>> drivers/staging/media/tegra-video/vi.h | 6 +-
>>> drivers/staging/media/tegra-video/video.c | 8 +-
>>> drivers/staging/media/tegra-video/vip.c | 4 +-
>>> include/dt-bindings/clock/tegra30-car.h | 3 +-
>>> include/linux/host1x.h | 10 -
>>> include/linux/tegra-mipi-cal.h | 57 ++
>>> 26 files changed, 1657 insertions(+), 670 deletions(-)
>>> create mode 100644
>>> Documentation/devicetree/bindings/display/tegra/nvidia,tegra20-csi.yaml
>>> create mode 100644 drivers/gpu/host1x/tegra114-mipi.c
>>> create mode 100644 include/linux/tegra-mipi-cal.h
>>>
>>
