Enable some more nodes for the Xperia 10 III.

Signed-off-by: erebion <[email protected]>
---
Changes in v4:
- &pm6150l_flash: fix extra zero for led-max-microamp value accidentally added 
in v3 (this was setting the max value 10x to high), remove Lua's Reviewed-by
- rename touch-en-regulator patch: fix rebase mishap and remove a regulator 
that's not part of this patch series, remove Konrad's Reviewed-by
- IPA: remove redundant properties that are now set in sm6350-lena board DTS, 
remove Luca's Reviewed-by
- fix pm7250b thermals after a rebase mishap
- pm8350: disable PON, as pm6350 already has it enabled, remove Konrad's 
Reviewed-by
- rear_cam_sensor: fix gpio to use correct one
- remove includes that aren't actually used
- re-order alphabetically: &pm6150l_adc before &pm6150l_gpios
- remove a superfluous tab at the closing brace of rear-cam-flash-therm@2
- enable remaining i2c busses: fix rebase mishap
- fix firmware paths to use upper-case "Sony" instead of lower-case "sony" for 
consistency with other DTs, reset Luca's Reviewed-by
- remove rear_cam_sensor, as it does not work and I haven't found the issue, 
will submit later when I get it actually working
- Link to v3: 
https://patch.msgid.link/[email protected]

Changes in v3:
- re-order some properties, generic properties first, then qcom,*
- &pm6150l_flash: fix led-max-microamp value
- rename touch-en-regulator to regulator-touch-en (to keep any future 
fixed-regulator sorted together as well)
- Bluetooth: remove incorrect property that does not exist
- Bluetooth, &qup_uart1_cts: do not overwrite a bias-disable with bias-bus-hold 
as it is not necessary
- &pm7250b_vbus: fix regulator-max-microamp value
- Remove comment from reserved-memory as suggested by Konrad Dybcio
- Squashed the patch enabling IPA into the one enabling ADSP, CDSP & MPSS, as 
suggested by Luca Weiss (therefore not adding the Reviewed-by from Konrad 
Dybcio)
- Configure thermals for PMK8350, PM7250B, PM650L as used in pdx213
- Enable remaining i2c busses
- Link to v2: 
https://patch.msgid.link/[email protected]

Changes in v2:
- Remove panel_reset_pin that shouldn't be part of this patch series
- Remove incorrect reg from mpss
- Fix conflicting bias pinctrl, as pinctrl nodes from sm6350.dtsi already 
contain a bias-* property
- Fix incorrect unit name in &pmk8350_vadc
- Link to v1: 
https://patch.msgid.link/[email protected]

To: Bjorn Andersson <[email protected]>
To: Konrad Dybcio <[email protected]>
To: Rob Herring <[email protected]>
To: Krzysztof Kozlowski <[email protected]>
To: Conor Dooley <[email protected]>
Cc: [email protected]
Cc: [email protected]
Cc: [email protected]

---
erebion (12):
      arm64: dts: qcom: sm6350-lena: Add flash LED
      arm64: dts: qcom: sm6350-lena: rename touch-en-regulator
      arm64: dts: qcom: sm6350-lena: Add qcom,rmtfs-mem node
      arm64: dts: qcom: sm6350-lena: Enable ADSP, CDSP, IPA & MPSS
      arm64: dts: qcom: sm6350-lena: Enable Bluetooth
      arm64: dts: qcom: sm6350-lena: Enable wifi
      arm64: dts: qcom: sm6350-lena: Enable PM7250B
      arm64: dts: qcom: sm6350-lena: Enable PMK8350
      arm64: dts: qcom: sm6350-lena: Add PM7250B thermals
      arm64: dts: qcom: sm6350-lena: Add PMK8350 thermals
      arm64: dts: qcom: sm6350-lena: Add PM6150L thermals
      arm64: dts: qcom: sm6350-lena: enable remaining i2c busses

 .../dts/qcom/sm6350-sony-xperia-lena-pdx213.dts    | 457 ++++++++++++++++++++-
 1 file changed, 456 insertions(+), 1 deletion(-)
---
base-commit: e5e04726cdd043e309677071ab1b65a4b18f422b
change-id: 20260829-pdx213-upstream-3-d0b80f749b5b

Best regards,
--  
erebion <[email protected]>

Reply via email to