I have done everything you said. I have Auto Repeater set to RPT1 and the right offset.
I can hit the repeater if I dial it in manually, but if I used my programmed memory 0, i can hear people on the repeater/gateway, but when I key up the frequency still changes to say "OFF" and I don't transmit. Any clue? --- On Tue, 3/16/10, wiserobj <[email protected]> wrote: From: wiserobj <[email protected]> Subject: [DSTAR_DIGITAL] Re: IC-2820H transmit says "OFF" To: [email protected] Date: Tuesday, March 16, 2010, 10:16 AM In the software go to "COMMON", and make sure Auto Repeater is set to RPT1. Or, on the radio make sure under "DUP/TONE" your offset frequency is set to the correct offset. The go into the "Menu", select "SET MODE", and set "AUTO REPEATER" to RPT1 . Then reprogram the memory channel. Without this RPT1 set this way you will get "OFF" in a memory channel for the offset.(see page 35 of the manual) Bob WB3W --- In dstar_digital@ yahoogroups. com, "Marlin" <imtheone2001@ ...> wrote: > > I just upgraded my IC-2200H to a IC-2820H. I using the ICOM software to > program it. I programmed in a memory channel with my repeater info (my call, > ur, rpt 1, rpt2, etc), but when I try to transmit, the IC-2820 display > literally reads "OFF" and I can't transmit. > > If I dial in the repeater manually, I can hit it. Is there some other > setting I am missing via the software that won't let me transmit when > using a memory channel? > > thanks, > Marlin > KD5IVK >
