Mike, you might try putting the 710 in packet mode to make sure that it is seeing a signal on the 9600 baud port.
Don WB5EKU On Mon, Aug 30, 2010 at 5:15 PM, Mike Besemer (WM4B) <[email protected]>wrote: > > > Anybody using the above combination? I got my NQSMHS build over the weekend > and tried getting things running today but cannot get rid of > the R2D2 on Echotest. > > I've been the full range of adjustment on the data terminal input and > output > levels via the MCP-2A software and have carefully adjusted the > RX and TX pots at each setting, but still get far too much R2D2. RF Read is > fine. > > The NQSMHS is interfaced to the rigs data terminal (9600 baud input) and > the > rig is running NFM mode on 2 meters. I'm transmitting to it > with an IC-80. > > Any thoughts? > > On a related note, I tried running the DVAR Hot Spot software to see if I > could listen to some traffic and adjust things further, but the > software says the GMSK modem is disabled? Didn't get a chance to > troubleshoot that much, but thought I'd toss it out there with my other > problem. > > 73, > > > Mike > WM4B > > >
