Correction. the status is reading 'Disabled'.
73, Mike WM4B _____ From: [email protected] [mailto:[email protected]] On Behalf Of Mike Sent: Monday, August 30, 2010 10:23 PM To: [email protected] Subject: [DSTAR_DIGITAL] Re: NQSMHS with TM-D710A Ha! Success (sort of)! I set Menu 517 (Ext Data Band) to 'A' (it already was) and Menu 518 (DATA Terminal Speed) to 9600 (it WAS set to 1200). Audio coming back from Echotest is now good! Now... why the heck does the DVAR Hotspot software (v 2.57) report the GMSK Adapter status as "GMSK Node Adapter Not Found". NAWinCFG seems to have no trouble finding it. 73, Mike WM4B --- In [email protected] <mailto:dstar_digital%40yahoogroups.com> , "Mike Besemer \(WM4B\)" <mwbese...@...> wrote: > > Anybody using the above combination? I got my NQSMHS build over the weekend > and tried getting things running today but cannot get rid of > the R2D2 on Echotest. > > > I've been the full range of adjustment on the data terminal input and output > levels via the MCP-2A software and have carefully adjusted the > RX and TX pots at each setting, but still get far too much R2D2. RF Read is > fine. > > The NQSMHS is interfaced to the rigs data terminal (9600 baud input) and the > rig is running NFM mode on 2 meters. I'm transmitting to it > with an IC-80. > > Any thoughts? > > On a related note, I tried running the DVAR Hot Spot software to see if I > could listen to some traffic and adjust things further, but the > software says the GMSK modem is disabled? Didn't get a chance to > troubleshoot that much, but thought I'd toss it out there with my other > problem. > > 73, > > > Mike > WM4B >
