If you gotten as far as Scott Holder suggested below and you are trying
to figure out if it's the motherboard or the power supply, you might
want to try the following.

1) Disconnect AC power cord.

2) Disconnect power supply connector from motherboard. ( the white
plastic connector with 12 wires ) (NOT the ribbon cable)
    The connector has two rows of six wires going into it.

3) Connect the AC power cord.

4) with a voltmeter look for a voltage with a magnitude greater than 19
volts DC between

                                               n
this point (blue wire )---- o o o o o o ----- and this point (black
wire)
                                        o o o o o o

The n above indicates the position of the plastic locking tab when you
are facing all the connector holes.

If you are getting around 0 volts between these two points, the problem
is with your power supply.

stephen kenda


snip

>
First thing I'd do is listen for a ticking noise. If it's ticking, it's
       the dreaded Tick of Death. This can be fixed either with a new
power
       supply, or replacing a capacitor if you don't have semi-1337
soldering
       skills.

       Next you can pop the top off (Grab the front edge of the two
sides (the
       vertical parts), squeeze, and lift. I believe it has ridges) and
watch
       while pushing a Duo in to see if anything is blocking. There
should be a
       spring-return slider on the left side with a little tab that goes

       between two little black boxes. When that crosses the black
boxes, the
       mechanism should fire. You can push this manually and see if it
goes. If
       not, it's either not getting power or the inject/eject mechanism
isn't
       working. You can check this by removing the big motor thingy with
a few
       screws on it and manually sticking the Duo on the connector. If
it then
       powers up, then it's the mechanism. If not, it's the power supply
or
       motherboard. From there, it gets tougher figuring out which one
is the
       problem :) There's a site somewhere that describes how to make a
Mac
       power supply power up manually, but I can't find it. Anyone got
it?

       And that is the quick version of dock diagnosis :)

       Scott Holder
<
end of snip


----------
Duo/2400 List, The friendliest place on the Net!
A listserv for users and fans of Mac subportables.
FAQ at <http://www.themacintoshguy.com/lists/DuoListFAQ.shtml>
Be sure to visit Mac2400! <http://www.sineware.com/mac2400>

To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
Need help from a real person? Try.  <[EMAIL PROTECTED]>

----------
Dr. Bott  | 10/100 Ethernet for your 2400 is finally here!
MPC-100   | <http://www.drbott.com/prod/mpc100.html>

  RoadTools $30 PodiumPad available at Apple retail stores, $20 Traveler 
  CoolPad at Staples. Both in white for iBooks at <http://roadtools.com>

Midwest Mac Parts  ][  <http://www.midwestmac.com>  
After-market parts  for Macs.   ][  888-356-1104 ][

MacResQ Specials: LaCie SCSI CDR From $99! PowerBook 3400/200 Only $879! 
Norton AntiVirus 6 Only $19! We Stock PARTS! <http://www.macresq.com>

Reply via email to