Not true Paul... The Mode command can simultaneously set width... but I'm sure if one can get at the necessary bytes with DX4Win... I'll take a look tomorrow.
> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Paul Ferguson > Sent: December 29, 2003 17:07 > To: [email protected] > Subject: Re: [Dx4win] IC-765 control question > > > > We noticed that clicking on a CW spot would properly send > the radio to > > the frequency, but would set the CW filter to Wide. Is there a > > modification to the radio control file for the 765 which > will send the > > radio to the proper frequency but set the filter at Narrow? > > ICOM did not provide, in the IC-765 CI-V interface, a command that > will set the Wide versus Narrow mode for the IC-765 IF passband. If a > program sends a command to the IC-765 to set the operating mode, the > 765 will set wide mode. > > If you can make the radio control fiileset just send the set > frequency command, the mode will be left where it was previously set > (such as CW-Narrow). > > 73, > Paul > K5ESW > > _______________________________________________ > Dx4win mailing list > [email protected] http://mailman.qth.net/mailman/listinfo/dx4win >
