I was just fooling around with the new version of DX4WIN and trying to set it up for SO2R. I have a Kenwood TS-2000 and an Elecraft K2. My SO2R box is a Top Ten Devices DX Doubler. Up until now while using DX4WIN I would just go to preferences and change the radio port and the radio type to the correct values for the radio I wanted to use. This worked fine but was a little cumbersome. After trying a few things I find that with V6.01 I can do the same thing (just set up one radio in preferences) and it seems to work the same way. The freq and mode show up OK. When I set up two radios in preferences and if I leave the DX Doubler in manual mode the freq and mode are read correctly and change to the other radio's values when I hit SHIFT-CTRL-F12 (the new V6.01 command to switch to the other radio). I must manually switch the DX Doubler to get to Mike , earphones, etc. to the correct radio (because it's in manual mode). All works well in this mode. When I put the DX Doubler into AUTO mode I have a problem. The SHIFT-CTRL-F12 command switches the DX Doubler to the other radio and the mode/freq displayed follows the radio change correctly but both radios are put into transmit mode with a sidetone as if the CW line is set on for both at the same time. No matter what I do this does not change. The CW keyer interface in preferences is set to LPT1 and the radio 1/2 signal is set to LPT1. I've shut each off one at a time with no luck. I've tried different setting for DTR and RTS in preferences with no luck. HELP
Roger, W1EM
