Hi Roger, To me it looks like your DEVICE can't handle correctly the output from LPT port or doesn't switch like it is intended to work.
How it works, WHEN RADIO1 is SELECTED and if 1/2 signal is selected, your LPT1 PIN 14 is HIGH = + 5Volt NOW SHIFT+CTRL+F12 AND RADIO2 is SELECTED also with 1/2 signal selected, your LPT1 PIN 14 is LOW = 0 Volt Go to my web and look @ the picture I putted on a few minutes ago 73 Guy ON4AOI BAND DECODER and related stuff at http://www.on4aoi.be/banddecoder.htm DX4WIN soft and related stuff at http://www.on4aoi.be/dx4win.htm DX4WIN, WRITELOG, WF1B & RITTY CW & RTTY interfaces at http://www.on4aoi.be/keyer.htm ARSWIN link and related stuff at http://www.on4aoi.be/web7.htm DXTELNET soft and related stuff at http://www.on4aoi.be/dxt.htm MY SALESPAGE with radioamateur & computer parts http://www.on4aoi.be/sale.htm ----- Original Message ----- From: "Roger Marrotte" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, January 29, 2003 10:55 PM Subject: [Dx4win] V6.01 SO2R > I was just fooling around with the new version of DX4WIN and trying to set > it up for SO2R. I have a Kenwood TS-2000 and an Elecraft K2. My SO2R box > is a Top Ten Devices DX Doubler. Up until now while using DX4WIN I would > just go to preferences and change the radio port and the radio type to the > correct values for the radio I wanted to use. This worked fine but was a > little cumbersome. After trying a few things I find that with V6.01 I can > do the same thing (just set up one radio in preferences) and it seems to > work the same way. The freq and mode show up OK. When I set up two radios > in preferences and if I leave the DX Doubler in manual mode the freq and > mode are read correctly and change to the other radio's values when I hit > SHIFT-CTRL-F12 (the new V6.01 command to switch to the other radio). I must > manually switch the DX Doubler to get to Mike , earphones, etc. to the > correct radio (because it's in manual mode). All works well in this mode. > When I put the DX Doubler into AUTO mode I have a problem. The > SHIFT-CTRL-F12 command switches the DX Doubler to the other radio and the > mode/freq displayed follows the radio change correctly but both radios are > put into transmit mode with a sidetone as if the CW line is set on for both > at the same time. No matter what I do this does not change. The CW keyer > interface in preferences is set to LPT1 and the radio 1/2 signal is set to > LPT1. I've shut each off one at a time with no luck. I've tried different > setting for DTR and RTS in preferences with no luck. HELP > > Roger, W1EM > > > > _______________________________________________ > Dx4win mailing list > [email protected] > http://mailman.qth.net/mailman/listinfo/dx4win > >
