Hi Larry All you have to do is set the PTT delay to 500ms and you can use both functions with CW control enabled in the PSK window
73 Martin ON6MX ----- Original Message ----- From: "Roger Borowski" <[EMAIL PROTECTED]> To: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]>; <[email protected]> Sent: Sunday, October 26, 2003 3:43 PM Subject: Re: [Dx4win] PSK31 support for LPT keying > Larry, In Ver 6.0x, you have to geo into "Preferences" and "Control" and > switch the configuration from CW to PSK31 PTT and back and forth depending > on the mode you are using at the moment. In Ver. 5.02/03 the PTT keying port > was selectable in the PSK31 window. Now its a real pain to switch between > these modes as it requires you to go into Preferences and control each time > you change modes. I've alerted Paul numerous times about this and hopefully > it will be addressed in the next maintenance release. > 73, -=Rog-K9RB=- > > ----- Original Message ----- > From: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Sunday, October 26, 2003 6:25 AM > Subject: [Dx4win] PSK31 support for LPT keying > > > > Due to a shortage of serial ports, I use LPT1 to key CW in DX4WIN. This > > works fine for CW, but when operating in PSK31 mode, the LPT keyed line > does > > not seem to operate. I have gone into the PSK Tx preference window and > > checked the "use CW control" - but the LPT CW line does not work from PSK. > > (the frustrating fact is that PSK keying _does_ work under exactly the > same > > settings from the COM port - but my com ports are dedicated to other > > functions). > > > > Am I doing something wrong here ? > > > > -larry > > K8UT > > > > _______________________________________________ > > Dx4win mailing list > > [email protected] > > http://mailman.qth.net/mailman/listinfo/dx4win > > > > _______________________________________________ > Dx4win mailing list > [email protected] > http://mailman.qth.net/mailman/listinfo/dx4win > >
