Hi Can I have DX4Win save the address Telnet connection? Would like to be cluster on startup. I realize I connected to the internet.
Oh and I noticed if one isn't setup when box comes up with message -> No this point and dx4win via task-manager in WinXP. If I click .. say close, I get a box that reads - occurred. I click OK on that error message box and get that reads - The destination address is required. I back again. This is a loop. Thanks Mark - ve9ts -- From [EMAIL PROTECTED] Sat Nov 19 23:10:27 2005 From: [EMAIL PROTECTED] (Jim Reisert AD1C) Date: Sat Nov 19 23:17:17 2005 Subject: [Dx4win] Internet / Cluster - Telnet selection setup In-Reply-To: <[EMAIL PROTECTED]> References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> At 10:59 PM 11/19/2005, M. Fitz wrote: >Can I have DX4Win save the address use most often for Internet / >Telnet connection? Would like to be able to have dx4win connect >to the cluster on startup. I realize I would have to be dialed >up and already connected to the Internet. Yes, by editing the DX4WIN.TCP file in the DX4WIN "SAVE" directory. >Oh and I noticed if one isn't setup when you click connect, a >small box comes up with message -> No connection active. Should I >happen to change my mind at this point and click cancel or close, I >end up in a loop and have to exit dx4win via task-manager in WinXP. >If I click .. say close, I get a box that reads -n exception >occurred. I click OK on that error message box and get another >box that reads - The destination address is required. Ilick OK >and get the other box back again. This is a loop. What version of DX4WIN, Mark? This works properly on 7.01 73 - Jim AD1C -- Jim Reisert AD1C, 7 Charlemont Court, North Chelmsford, MA 01863 USA +978-251-9933, <[EMAIL PROTECTED]>, http://www.ad1c.us
