Is there any way I can convince DX4WIN to send commands to my Orion2 to set the appropriate band width for SSB or CW? Every time I click on a DX spot within DX4WIN the O2 changes frequency and mode but it's a crap shoot where the band width will end up. George W2YJ From [EMAIL PROTECTED] Thu Mar 22 08:47:33 2007 From: [EMAIL PROTECTED] (Dave Earnest) Date: Thu Mar 22 08:50:17 2007 Subject: [Dx4win] No P.T.T. again Message-ID: <[EMAIL PROTECTED]>
I finally solved this problem. I now have ptt on all digital modes. I did find that I can only have one mode selected at a time. Since I use one comport for fsk, cw, and ptt, I get conflict errors if I try to have MMTTY, PSK31, or CW keyboard up at same time. I also found that when switching from one mode to another, I must shut down one mode and exit DX4WIN and then open the program again and bring up the new mode. I don't use the CW keyboard normally, but wanted to make it work. I use a second comport for PSK operation, so don't quite understand why I can't have MMTTY and PSK up at the same time. For what it's worth. 73, Dave K7JJ From [EMAIL PROTECTED] Fri Mar 23 22:36:31 2007 From: [EMAIL PROTECTED] (ao.rangi) Date: Fri Mar 23 22:39:28 2007 Subject: [Dx4win] Filter Help In-Reply-To: <[EMAIL PROTECTED]> References: <[EMAIL PROTECTED]> Message-ID: <[EMAIL PROTECTED]> Is there a way to filter for the following? Needed for DXCC and Method = DIRECT and Cnfm = N Any help would be appreciated. Bryan, Zl1NI
