Easier to do in person. Basic ideas: Run in CW part of band first and get signal on the screen. Should be blue/gray background with yellow signal (something like that, going by memory don't do too often). Makes sure wide filter and there is a slider for shooting for 0 when no signal (and + numbers when signal). When you see a signal, go to 14.076 and see if you find some JT65 there. Make sure either digital mode or USB depending on what radio recommends. If you hear something, it should decode at the end of the minute (46 seconds after). Do that a bit until you are comfortable receiving. Then TX is a combination of speaker output from the PC and radio mic gain along with PTT. More difficult but get the RX first.
This all assumes you have the audio lines from the PC to the radio correct. May need to find a local friend who has done it. Dan KI6X -----Original Message----- From: DX4WIN [mailto:[email protected]] On Behalf Of Courtney Judd Sent: Thursday, August 11, 2016 3:03 PM To: Joe Subich, W4TV <[email protected]> Cc: ACG <[email protected]>; SECC <[email protected]>; [email protected] Subject: Re: [Dx4win] JT65A ok, I use a 2000D hooked to my computer via a microKeyer 2 by microHAM. I downloaded JT65-hf and it seemed to be much simpler. I have com port 3 for keying and rig control/freq etc selected as it is that way in the microHAM router. BUT, it will key but no audio received or sent and no freq showing. I have tried all combos of listed devices and no luck. Somehow I knew that this was not going to be easy!! lol any help/ideas? thanks Cort K4WI > Joe Subich, W4TV <mailto:[email protected]> Thursday, August 11, 2016 > 10:32 AM > > On 8/11/2016 10:40 AM, Björn Ekelund wrote: > > If you use any of Microham's USB enabled units (CW keyers, TNC, rig > > controllers...) this functionality is built in. > > Only microHAM "Keyer" series interfaces (microkeyer, microkeyer II, > digikeyer, digikeyer II, CW Keyer or MK2R+). USB Interface II and USB > Interface III do not provide the CAT/2nd CAT capability as they have > no internal microprocessor. > > 73, > > ... Joe, W4TV > > > > ______________________________________________________________ > DX4WIN mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html ______________________________________________________________ DX4WIN mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ DX4WIN mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
