Dave, Look for portmap file in the on-line help; it allows remapping for LP ports.
--Paul On Mon, Dec 17, 2018 at 11:07 PM Joe Subich, W4TV <[email protected]> wrote: > > Dave, > > In Windows Device Manager -> Ports (COM & LPT) you associate a Legacy > LPT Port Number (LPT1, LPT2, or LPT3) with your PCIe LPT port (Port > Settings tab for that port). While N1MM+ uses the port address from the > Resources tab, DX4win uses the Legacy Port Number (LPT1, LPT2, or LPT3) > to identify the LPT port for radio 1/2 signal (Parameters -> CW). > > 73, > > ... Joe, W4TV > > > On 2018-12-17 10:26 PM, N4QS, Dave Perry wrote: > > Alan, I did have to install the lptdriver as you suggested, but I also > had > > to reset the LPT port address in N1MM+ to match the address for the new > PCIe > > card. The DXD works fine now in N1MM, but I can't see a way to change > the > > address in DX4WIN. I have emailed Paul. Thanks for the assist. 73, > Dave - > > N4QS > > > > > > -----Original Message----- > > From: Alan Walters <[email protected]> > > Sent: Sunday, December 16, 2018 3:18 PM > > To: [email protected]; [email protected] > > Subject: RE: [Dx4win] Expert mode and DX Doubler > > > > Dave, I too am using my DX Doubler with 9.0.4 with Win7. I wonder if you > > have installed the lptdriver? Assuming you installed DX4W directly in C: > > drive, you will find this at C:/dx4w/drivers/lptdriver. > > > > Al, K5NOF > > > > -----Original Message----- > > From: [email protected] [mailto: > [email protected]] > > On Behalf Of [email protected] > > Sent: Sunday, December 16, 2018 12:51 PM > > To: [email protected] > > Subject: [Dx4win] Expert mode and DX Doubler > > > > I am trying to reinstall my legacy DX Doubler SO2R box with DX4WIN ver > > 9.0.4. It used to work great under version 8.5. When I go to > Preferences, > > Control tab, I cannot change the Type or LPT1 port under Band Decoder. > With > > version 9.04, the type is grayed out as None under Band decoder. As I > > recall, you used to have to go into the Personal tab to turn on expert > mode > > to change this, but that is no longer available. Is Top Ten Devices > using a > > LPT port still supported in Version 9? And can anyone tell me what > happened > > to Expert Mode? Thanks, Dave, N4QS > > > ______________________________________________________________ > DX4WIN mailing list > Home: http://mailman.qth.net/mailman/listinfo/dx4win > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > Message delivered to [email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- ~~~~~~~~~~~~~~~~~~~~~ DX4WIN logging software Paul van der Eijk, KK4HD BrookHill Data Systems LLC http://www.dx4win.com ______________________________________________________________ DX4WIN mailing list Home: http://mailman.qth.net/mailman/listinfo/dx4win Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] Message delivered to [email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
