Eugene, Maybe you don't have user options set correctly. The settings we use for the FT1000mp are 4800, 8, N, 2. It's possible you changed the baud rate in your radio, if so, you would need to use the corresponding baud rate in DXbase user options. Also, make sure you don't have some other device also using the same comport or IRQ.
Regards, Jack ----- Original Message ----- From: "Brendan Minish" <[EMAIL PROTECTED]> To: "Eugene Bugrimov" <[EMAIL PROTECTED]>; "DXBase" <[email protected]> Sent: Monday, December 02, 2002 7:53 PM Subject: Re: [DXBase] problems with CAT > Hi Eugene, > > Does this happen all the time or just sometimes ? > > I have problems with both my radios ( ICOM 756PRO2 & elecraft K2 ) where > DXB (2003 & 2002 ) > sometimes messes up sending the commands to the radio, this affects > spotting, clicking spots and logging. > This happens on 3 different Win2k PC's I have tried, I currently have no > way of testing on a non win2k PC > > What happens is that DXB sometimes fails to send the first command to the > radio correctly (it only sends the first byte of the command ) > I was able to observe this behavior using another com port and some > software to monitor RS232 Data. > > it would be interesting to see if others are having problems with rig > control under win2k (& XP?) on systems that worked ok under win98. > > > > At 17:22 02/12/2002 +0300, Eugene Bugrimov wrote: > >Hi > > > >I have problem - used earlier a computer together with FT-1000MP and > >DXBase-2000 (P-233, Win-98). > > > >Has got a new computer (AMD K7-600, Win-2000). > > > >Now at me CAT does not fulfil as is put. At transfer of a command from a > >computer the indicator in FT-1000MP burns, but is switched to the necessary > >frequency not always. > > > >At record of new QSO into LOG, the data from transceiver it is incorrect. > > > >In what there can be a problem? > > > >Best wishes! > >Eugene Bugrimov, RN9XA > > > >_______________________________________________ > >DXBase Reflector - Please visit us on the web at www.dxbase.com > >- - - - - - - - - - - - - - - - - - - - - - - > >To UNSUBSCRIBE please visit: > >http://mailman.qth.net/mailman/listinfo/dxbase > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
