Set up Dxbase 2004 last night. Had Dxbase 2002 running fine. Same machine, same ports.
I cannot get CW from LPT 1. COM ports seem to act OK, though the rotor on COM 3 has a problem not seen in Dxbase 2002. Commanding the rotor to move creates a situation where the whole machine freezes for 60-90 sec then the rotor moves to the correct position and the program resumes. I have used the driver update program and verified the ports in Control Panel. Any ideas what I should do next? BTW I still have Dxbase 2002 in a separate directory from 2004. Is this OK? Might it create conflicts of some type? Tnx Mike, N1MD Michael L. Therrien, MD, MMM, CPE Amateur Radio Station N1MD "Primum non nocere"
