Hi, Jack, Thanks for the reply, I did run the DXCC module, however, It didn't put my multible qso cards at the end...
I am running the module for DXCC, Have selected all the cards I need for the DXCC award by marking DXCC in Select, Run the wizard checking the select and DXCCputting the records in the report table. Then run the DXCC award module selecting cards only and wizard records. I did select all the QSO's on the multiple QSO Cards so far, still only puts one qso on the report for multiple QSO Cards and orders it as if is a single qso card. I've done something wrong, Any ideas? Best wishes. rich K5SF >From: "Jack" <[EMAIL PROTECTED]> >To: "Richard Detweiler" <[EMAIL PROTECTED]>,<[email protected]> >Subject: Re: [Dxbase] ModifiedDxccqso.rpt >Date: Wed, 18 May 2005 11:16:39 -0400 > >Rich, > >The logic for this was enhanced in DXbase 2006 so that this report is no >longer required. The logic in 2006 now sorts exactly as the ARRL specifies >it should. Just run the DXCC awards module and that's it. > >Jack > >----- Original Message ----- From: "Richard Detweiler" ><[EMAIL PROTECTED]> >To: <[email protected]> >Sent: Wednesday, May 18, 2005 10:50 AM >Subject: [Dxbase] ModifiedDxccqso.rpt > > >>Where can I find the "ModifiedDxccqso.rpt" from Joe WA6AXE. >> >>And do I need it for DXCC? I have several cards that have multiple >>entries, >> >>Would like them to sort to the end as it should. >> >>btw the reflector is bouncing all my messages today.. >> >> >>best wishes, >>Rich >>K5SF >> >> >>______________________________________________________________ >>Dxbase mailing list >>Home: http://mailman.qth.net/mailman/listinfo/dxbase >>Help: http://mailman.qth.net/mmfaq.htm >>Post: mailto:[email protected] >> >
