Still no go. I changed the User Options/Internet IP Host box to 127.0.0.1 localhost ypoxkjlg node, verified that VE7CC ARU configuration is set to Telnet on both Port Setup and Logging Program Connection. Not sure about setting the login info. All are left at default values or blank. When I try to connect via Window/New Internet I get the error message "could not connect to the site!". When I click on OK, another error message, "Packet Comm Mgr initialization failed. Check user options, hardware options, or internet connection...". Connection is via a DSL modem and appears to be running ok. I've rebooted both DXB and VE7CC ARU without success. I must still be missing some other option. Gary AL9A
----- Original Message ----- From: "FireBrick" <[EMAIL PROTECTED]> To: "Gary Senesac AL9A" <[EMAIL PROTECTED]>; "DXbase Reflector" <[email protected]> Sent: May 25, 2005 2:59 PM Subject: Re: [Dxbase] VE7CC & DXB spots > ARU must be running. But after your up and running, you can minimize it totally.. > In DXB, Internet Options, choose 127.0.0.1 localhost ypoxkjlg as the node you will be > connecting to. Set your login, no password is needed. > > In ARU. > Go to Configuration, Port Setup, and click on Telnet in the Node Selection box > and > click on Telnet again in the Logging Program Connection box. > > Connect to a ARU node, I like N5IN, VE7CC, K1TTT and others. > Now go back to DXB and connect via Window, New Internet Cluster. > > Once your up, you can filter till your little hearts desire. > > Good luck. > > > ----- Original Message ----- > From: "Gary Senesac AL9A" <[EMAIL PROTECTED]> > To: "DXbase Reflector" <[email protected]> > Sent: Wednesday, May 25, 2005 5:31 PM > Subject: [Dxbase] VE7CC & DXB spots > > > > OK, on to the next challenge. I've downloaded, installed and gotten the > > VE7CC AR User software up and running. It seems to work great by itself, > > but I can't get any spots to show up in the DXB DX Info window. I've gone > > to Configuration/Ports/Logging Program and clicked on Telnet for both the > > node connection and the logging program connection, but no spots show up. > > Am I supposed to leave the VE7CC software up and running, or do I disconnect > > and open the connection via the internet window in DXB? I know I've seen > > several positive comments about the VE7CC package and the DXB interface so I > > know it must work, I just don't know what I've missed so far. Any and all > > help appreciated. > > 73, > > Gary AL9A > > > > ______________________________________________________________ > > Dxbase mailing list > > Home: http://mailman.qth.net/mailman/listinfo/dxbase > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > >
