On Sat, 3 Dec 2005 21:21:05 -0600 "FireBrick" <[EMAIL PROTECTED]> wrote:
Thanks replay. Of course I can be connected to outside cluster. only I can connect local network cluster. That IP address is 192.168.1.20. I changed a host file first. I wrote 192.168.1.20:7300 # JE2UFF as last line in host file. I chose Internet among a Tool command and chose the host who added it some time ago afterwards.However, there is a state until now that is the connect result without being strange. Why may not you be connected to a host in a local network? My network router address is 192.168.1.1 , it is default setting value. There is not only DXBase2006 to be able to be connected in other software. Choosing host which I added by a change of a host file, Internet setting, will there be an anything setting method elsewhere? best regards! > Toshi > I'm not sure exactly what your doing. > But.... > 192.168.1.20:7300 is usually an IP from a router. > > If you wish to connect to a cluster than you should use that cluster's IP > directly. > In Tools>Options>User Options click on Internet. > Then where it says IP Host, choose the cluster you wish to connect with. > > If the cluster you want to use is not listed, than you must use File>Modify > Host File and > enter it. > > Hope this is what you were asking about. > > > ----- Original Message ----- > From: "Toshimi Horie" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Saturday, December 03, 2005 7:47 PM > Subject: [Dxbase] can not connect Internet cluster > > > > Hi all. > > > > My name is toshi, can use DXBase2006. It is nice sw. But now I have > > one problem in this software setting. > > > > Now running DX-spider software in my local network. It can use DDNS. > > so outside my network, can use domain. but inside.normaly use private > > address. one exsample, I can use RXCLUS then set up node address was > > 192.168.1.20 and port was 7300. It can connect DX-Spider from RXCLUS. > > > > But DXBase 2006 was same setting, host file modificated (add local IP) > > wrote as follows 192.168.1.20:7300 > > but can not connect local DX-Spider host, DXBase2006as show > > "could not connect this site" > > > > Why other software (DX-telnet, RXCLUS,windows-telnet,etc) can connect > > host, Why can not connect DXBase2006. > > > > Who's know this countermager. Please tell me aonther set up. > > > > -- > > Toshimi Horie <[EMAIL PROTECTED]> > > > > ______________________________________________________________ > > Dxbase mailing list > > Home: http://mailman.qth.net/mailman/listinfo/dxbase > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > -- Toshimi Horie <[EMAIL PROTECTED]>
