Toshi Instead of 192....etc try the Local host ip 127.0.0.1:7300 localhost ypoxkjlg
which should be the first line in your host file you can check that by using File>Modify Host file That what I use to transfer cluster spots from ARUser which is connected to a Spyder Cluster. ----- Original Message ----- From: "Toshimi Horie" <[EMAIL PROTECTED]> To: "FireBrick" <[EMAIL PROTECTED]>; <[email protected]> Sent: Saturday, December 03, 2005 11:59 PM Subject: Re: [Dxbase] can not connect Internet cluster > > On Sat, 3 Dec 2005 21:21:05 -0600 > "FireBrick" <[EMAIL PROTECTED]> wrote: > > Thanks replay. > > Of course I can be connected to outside cluster. > only I can connect local network cluster. That IP address is > 192.168.1.20. > > I changed a host file first. > I wrote 192.168.1.20:7300 # JE2UFF as last line in host file. > > I chose Internet among a Tool command and chose the host who added it > some time ago afterwards.However, there is a state until now that is > the connect result without being strange. > > Why may not you be connected to a host in a local network? > > My network router address is 192.168.1.1 , it is default setting value. > > There is not only DXBase2006 to be able to be connected in other > software. Choosing host which I added by a change of a host file, > Internet setting, will there be an anything setting method elsewhere? > > best regards! > >> Toshi >> I'm not sure exactly what your doing. >> But.... >> 192.168.1.20:7300 is usually an IP from a router. >> >> If you wish to connect to a cluster than you should use that cluster's IP >> directly. >> In Tools>Options>User Options click on Internet. >> Then where it says IP Host, choose the cluster you wish to connect with. >> >> If the cluster you want to use is not listed, than you must use File>Modify >> Host File >> and >> enter it. >> >> Hope this is what you were asking about. >> >> >> ----- Original Message ----- >> From: "Toshimi Horie" <[EMAIL PROTECTED]> >> To: <[email protected]> >> Sent: Saturday, December 03, 2005 7:47 PM >> Subject: [Dxbase] can not connect Internet cluster >> >> >> > Hi all. >> > >> > My name is toshi, can use DXBase2006. It is nice sw. But now I have >> > one problem in this software setting. >> > >> > Now running DX-spider software in my local network. It can use DDNS. >> > so outside my network, can use domain. but inside.normaly use private >> > address. one exsample, I can use RXCLUS then set up node address was >> > 192.168.1.20 and port was 7300. It can connect DX-Spider from RXCLUS. >> > >> > But DXBase 2006 was same setting, host file modificated (add local IP) >> > wrote as follows 192.168.1.20:7300 >> > but can not connect local DX-Spider host, DXBase2006as show >> > "could not connect this site" >> > >> > Why other software (DX-telnet, RXCLUS,windows-telnet,etc) can connect >> > host, Why can not connect DXBase2006. >> > >> > Who's know this countermager. Please tell me aonther set up. >> > >> > -- >> > Toshimi Horie <[EMAIL PROTECTED]> >> > >> > ______________________________________________________________ >> > Dxbase mailing list >> > Home: http://mailman.qth.net/mailman/listinfo/dxbase >> > Help: http://mailman.qth.net/mmfaq.htm >> > Post: mailto:[email protected] >> > >> > > -- > Toshimi Horie <[EMAIL PROTECTED]> > >
