Port page shows the freq as noted on the Ft 1kd. Com ports agree which is 3. And the stop bits is 2. Guess I'll need to talk to someone at MicroHam.
-----Original Message----- From: FireBrick [mailto:[EMAIL PROTECTED] Sent: Friday, January 12, 2007 6:35 PM To: Dr. Michael Hunter Subject: Re: [Dxbase] DXBase & MicroHam It should work Mike I use it here. Take a look at the mHK ports page at the top the rig and frequency/mode should be displayed. If not then your not communicating properly. "What we have here....is a failure to communicate!" (name the movie) Whatever port is entered into the Control field should equal the port selected in the rig window of the DXB setup window. You didn't say what rig..... the common gotcha if your using a Yaesu is the 2 (two) stop bits issue. ----- Original Message ----- From: "Dr. Michael Hunter" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, January 12, 2007 6:10 PM Subject: [Dxbase] DXBase & MicroHam > Just hooked up the new Microham last week and worked fine in the RU RTTY > Test. Noticed when I have DXbase working, that the freq does not show or > the > band. When I click on the DX station coming through on the internet, the > freq will not change. When I use Writelog, the freq will be noted. So, I > click on the Microham router first and the freq is listed on the port tab. > Then I start DxBase and the freq is not noted. The Com ports are the same > which is Com 3. > > > > So any suggestion as to what is missing in DxBase ? > > > > Mike > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected]
