That was it ! I needed to check the " Connect Radio 1 Serial interface box " which is actually shown in the picture ! Dah Thanks for pointing me in the right direction.
Mike -----Original Message----- From: Tony Cash [mailto:[EMAIL PROTECTED] Sent: Friday, January 12, 2007 10:40 PM To: 'Dr. Michael Hunter' Subject: RE: [Dxbase] DXBase & MicroHam Does the Baud rate in DXB match with the radio? Do you have DTR, RST or CTS checked in the radio 1 setup? I know I must check RST for it to work with my TS2K. Do you have the "Connect Radio 1 Serial Interface" box checked? This must be checked before the radio will work. 73 de Tony, KD4K -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dr. Michael Hunter Sent: Friday, January 12, 2007 8:48 PM To: [email protected] Subject: RE: [Dxbase] DXBase & MicroHam The DXB rig tab I assume is the Radio1 under user options ? And yes when I click the QSY box, nothing happens. My CAT system light is on, and my freq changes under the Microham Router. -----Original Message----- From: FireBrick [mailto:[EMAIL PROTECTED] Sent: Friday, January 12, 2007 6:54 PM To: [EMAIL PROTECTED] Subject: RE: [Dxbase] DXBase & MicroHam forgive me for asking, you do have the rig 'enabled' in the DXB rig tab? and when you click on a cluster spot in the 'qsy' box, nothing happens? On 1/12/2007 6:47:44 PM, Dr. Michael Hunter ([EMAIL PROTECTED]) wrote: > Port page shows the freq as noted on the Ft 1kd. Com ports agree which > is > 3. And the stop bits is 2. Guess > I'll need to talk to someone at MicroHam. > > > > -----Original Message----- > From: FireBrick [mailto:[EMAIL PROTECTED] > Sent: Friday, January 12, 2007 6:35 PM > To: Dr. Michael Hunter > Subject: Re: [Dxbase] DXBase & MicroHam > > It should work Mike > I use it here. > Take a look at the mHK ports page > at the top the rig and frequency/mode should be displayed. > > If not then your not communicating properly. > "What we have here....is a failure to communicate!" > > (name the movie) > > Whatever port is entered into the Control field should equal the port > selected in the rig window of the DXB setup window. > You didn't > say what rig..... > the common gotcha if your using a Yaesu is the 2 (two) stop bits issue. > > > > ----- Original Message ----- > From: "Dr. Michael Hunter" <[EMAIL PROTECTED]> > To: <[email protected]> > Sent: Friday, January 12, 2007 6:10 PM > Subject: [Dxbase] DXBase & MicroHam > > > > Just hooked up the new Microham last week and worked fine in the RU > RTTY ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.16.9/623 - Release Date: 1/11/2007 3:33 PM -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.16.9/623 - Release Date: 1/11/2007 3:33 PM
