I was using this function with IC-746 for last 2 years with no problem, with ANY baud rate...till today. You can call it a miracle, but TODAY it stopped working. Exactly the same way as couple of months ago the internal CW engine "died". I've checked the settings, connections, rebooted the PC, transceiver...Nothing. And the same story as yours: both CT17 and keying interface still working with other programs and same IC-746 (non-PRO).
73! Ilya 4Z1UF -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Joe Gore Sent: Monday, September 03, 2007 4:16 PM To: [email protected] Subject: [Dxbase] DXbase and IC-746Pro I have just switched from a Kenwood radio to the IC-746Pro. DXbase will get the radio information (freq, mode) when I manually put the callsign in the log, but if I click on a spot, nothing happens except that I get the "not responding" message. My interface works with N1MM Logger, Ham Radio Deluxe and Amateur Contact Log just fine. I have tried different combinations of port, speed, DTR/RTS/CTS, etc. The initial pacing value in radios.ini was 8, but I've tried 15 and 50 as well. Can anyone help with this problem? 73, Joe WA4RTE ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
