On Sun, 2009-10-04 at 12:10 +0000, [email protected] wrote: > Good Morning Neal.. > while were on this subject can your or anyone else tell me why my 756 pro III > wont report the split frequency when I spot a country ?
Because ICOM's Protocol does not provide any way to read IF the rig is in Spilt TX or not, It can be set but not read. this applies to all of ICOM's radios, including the 7800, 7600 etc There is no command or sequence of commands that can be used to ascertain if the radio is currently in Split TX or not, you can read VFO B but you can't tell if it's the current TX VFO or not You can take this up with ICOM (as many have in the past 15 years or so..) but I suspect your request will fall on deaf ears -- 73 Brendan EI6IZ ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
