Tom, The ICONs for switching between radio1 and radio2 only control which radio is accessed when retrieving or sending frequency/mode info. It has nothing to do with the keyer interface. There is nothing in DXbase that switches the Winkey between two different radios. Perhaps there is a manual switch on the Winkey that lets you direct the keying between different radios, I don't really know. But as far as DXbase is concerned, the keying is sent from DXbase to the Winkey and where it goes after that is controlled in Winkey.
Regards, Jack ----- Original Message ----- From: "Tom Lewis" <[email protected]> To: "dxbase" <[email protected]> Sent: Saturday, October 10, 2009 7:30 AM Subject: [Dxbase] K1EL Winkeyer USB > > I added a K1EL Winkeyer USB to my station. In stand alone mode it keys > radio one or two fine. > > With DXbase 2007 I can't get it to change between radios. The "Use Radio > 2" > icon up or down does not matter. > > Does anyone know how to get it to switch between radios? > > Thanks > Tom, N4TL > > > > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
