Hi Ed, As Dave in another message noted, double check your printer settings, but also double check the 'print job' in the DxBase card template as each job can have its own printer set-up. DxB will automatically scale for you as I use a couple of my templates for both QSL cards and 'eye-ball' cards and the final card scales quite nicely, both up and down in sizes.
Personally I prefer to print single QSL cards. My reasoning is if I get a direct request via mail I need only print the one card directly from DxB and not wait until I have 4 QSL requests in the queue. I do print the 'eye-ball' cards 10 at a time per page. For the QSL cards, I buy 120 lb coated one-side stock from a local print shop and have them pre-cut the stock to 3-1/2 x 5-1/2 postcard size in their power shears. This way, I don't have to muss with cutting and dull blades in my cutting mat. HNY, Eric - VE3GSI > -----Original Message----- > From: Ed K1EP > Sent: December-29-09 10:11 AM > To: [email protected] > Subject: [Dxbase] Printing QSLs four up > > I normally print QSL cards one at a time. I decided to try and print > the same cards four up on heavy stock and then cut them. When I > print the cards four up, they come out half size, as the printer > shrinks them. Is there an easy way to print four up without having > to scale the card? Or if I do have to scale the card, is there an > easy way to do that instead of editing every object? > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
