Bill, Now I am wondering WHAT is going on --- you should NEVER this come up -- Bill -- if you would -- pse ZIP up your refdata.mdb file and also ZIP up your Logbook mdb file and email BOTH of them to me -- so that I can RUN both of them against my program here at my qth --- DXbase2007 is made under the MSJet that ACCESS97 uses -- and we ALWAYS MUST make very sure that we NEVER convert any of our files to ACCESS2000 format --- let me check your files here and see what is going on ....
Joe > From: [email protected] > To: [email protected]; [email protected]; [email protected] > Subject: RE: [Dxbase] CONVERT TO ACCESS 2000 > Date: Thu, 10 Feb 2011 10:53:48 -0600 > > Joe, > > I tried to use it this morning and it ask me the same thing. I thought it > was just my computer and decided to not chance the conversion. I guess I > did good! > > Bill W5VX > > -----Original Message----- > From: [email protected] [mailto:[email protected]] > On Behalf Of Joe WA6AXE > Sent: Thursday, February 10, 2011 10:45 AM > To: [email protected]; [email protected] > Subject: Re: [Dxbase] CONVERT TO ACCESS 2000 > Importance: High > > > Art, > > PSE restore your SAVED logbook.mdb file and your Refdata.mdb file -- > > We never CONVERT our mdb files into ACCESS 2000 format!!!! > > I do not know why it would tell you that -- but, that > is NOT what should be done --- > > What you can do, if you want --- > > RESTORE your SAVED logbook mdb file and refdata mdb file > so that you ARE OK there at ur qth -- > > then -- ZIP-up BOTH your logbook mdb file and your refdata.mdb file > and send the ZIP file to me at this email address (reply to me directly) .. > > I will check BOTH of them here at my QTH. > > Joe wa6axe > > > From: [email protected] > > To: [email protected] > > Date: Thu, 10 Feb 2011 11:27:43 -0500 > > Subject: [Dxbase] CONVERT TO ACCESS 2000 > > > > When trying the db checker, The program said that the file was created in > an > > earlier version of access and needed to be converted to 2000. I saved the > > current database and ref files and then converted both to access 2000. The > > program does not run. Was there more to do? I saved the updated files and > > restored the original files and operating fine . any ideas. Thanks Art > w1rzf > > > > ______________________________________________________________ > > Dxbase mailing list > > Home: http://mailman.qth.net/mailman/listinfo/dxbase > > Help: http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: http://www.qsl.net > > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
