Bob, I'm using for years CW Com port keyer with many versions of DXB, recently moved it to LPT port (needed COM for another purposes), works flawlessly, same as with N1MM. You can't use the same port for controlling the rig via DXB and for CW, it MUST be a separate ports. Stupid question: did you built in the keying circuit (transistor+resistor)? Barefoot COM can't drive the keyer input of your TRX...
73! Ilya, 4Z1UF > -----Original Message----- > From: [email protected] [mailto:dxbase- > [email protected]] On Behalf Of [email protected] > Sent: Saturday, December 10, 2011 6:41 PM > To: [email protected] > Subject: [Dxbase] CW keying with serial port. > > > I recently installed a 2 port PCI serial card in my Vista 64 bit computer for use > with rig control and cw keying. The rig control works great but no luck with the cw > keying. I have configured the port to com1 as well as dxbase to use com1. Not > sure what the problem might be. Any help would be appreciated. > > Bob > WB2UBW > ______________________________________________________________ > Dxbase mailing list > Home: http://mailman.qth.net/mailman/listinfo/dxbase > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Dxbase mailing list Home: http://mailman.qth.net/mailman/listinfo/dxbase Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
