----- Messaggio inoltrato da [EMAIL PROTECTED] -----
Data: Wed, 19 Mar 2008 11:13:45 +0100
Da: Davide Donetto <[EMAIL PROTECTED]>
Rispondi-A:Davide Donetto <[EMAIL PROTECTED]>
Oggetto: Re: [E-puck-user] linux serial programming
A: Alexandre Campo <[EMAIL PROTECTED]>
Quoting Alexandre Campo <[EMAIL PROTECTED]>:
> Indeed, sorry I forgot to mention that the rfocmm.conf file is
> assumed to be in this shape :
>
> rfcomm0 {device 08:00:17:2D:52:81;}
> rfcomm12 {device 08:00:17:2D:18:64;}
> rfcomm54 {device 08:00:17:2D:18:64;}
>
> .
it's not working anyway, I'll try to modify the regexp...
I've also used pieces of your code in my project:
I can get the e-puck connected but then it behaves the same as before.
I need to cycle the same instructions over and over:
read sensors
set speed
tipically it starts working for a few cycles and then begins to give
read errors
I'm desperate, it's always the same behavior!! It doesn't matter if I
use libserial or termios or bluetooth, or whatsoever (Stéphan, do you
REALLY think dashel could be of any use? I'm a bit tired about
learning new ways to cope with the e-puck and discover I'm always at
the same dead point. If you've had the same problems and you got past
them with dashel, please let me know!!!)
I'm sorry, I'm in a bad mood right now
Thanks for the help anyway
Davide
----- Fine del messaggio inoltrato -----
_______________________________________________
E-puck-user mailing list
[email protected]
https://mail.gna.org/listinfo/e-puck-user
