This doesn't sound quite right, and if it's following the driver then there might be a SW bug.
Can you send us the output of "ethtool -i <ethX>"? A full dmesg would be good, too, but attaching that to a bug on e1000.sourceforge.net would be the best since this list strips attachments. Todd Fujinaka Software Application Engineer Datacenter Engineering Group Intel Corporation todd.fujin...@intel.com (503) 712-4565 -----Original Message----- From: Thorvald Natvig [mailto:thorv...@medallia.com] Sent: Wednesday, September 6, 2017 6:52 PM To: e1000-de...@lists.sf.net Subject: [E1000-devel] Unsupported SFP+ in i40e 2.1.26, works in older versions On a EXL710QDA2G1P5 card, after upgrading the NVM to 6.01 and driver to 2.1.26 on kernel 4.10, we get "Rx/Tx is disabled on this device because an unsupported SFP+ module type was detected." This is a unlocked card, and when reverting to the default kernel driver in 4.10, or using the 2.0.30 driver, this problem goes away, but so does support for get_module_eeprom which was our reason for upgrading. Is this an intentional change? ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel To learn more about Intel® Ethernet, visit http://communities.intel.com/community/wired
