Hello, Also, when eth2 is in freeze state, running `ethtool -s eth2 port tp` solves the problem.
On Wed, May 21, 2008 at 7:13 PM, Ronciak, John <[EMAIL PROTECTED]> wrote: > Does the driver that comes with SLES10 work? Does eth0 or eth1 work? > > What is the output from: > ethtool <ethx> > ethtool -i <ethx> > netstate -i > ifconfig ethx > > > Cheers, > John > ----------------------------------------------------------- > "Those who would give up essential Liberty, to purchase a little > temporary Safety, deserve neither Liberty nor Safety.", Benjamin > Franklin 1755 > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Stanislav Bogatyrev > Sent: Wednesday, May 21, 2008 6:52 AM > To: e1000-devel@lists.sourceforge.net > Subject: [E1000-devel] e1000 freezing during boot > > Hello, All! > > I run SLES-10 Linux with kernel 2.6.16. When system boots up. It > configures network interfaces, but stays unreachable. When pingning > from a remote - we just don't get ARP reply. When pinging from > computer with the problem we see arp requests and arp replies (tcpdump > on the target), but those replies do not come to OS level. Compilation > with MSI disabled or with NAPI disabled doesn't solve the issue. > > Is there any workaround for this issue? > > kernel: 2.6.16-SLES10 > driver: e1000 > version: 7.6.15.5 > firmware-version: N/A > bus-info: 0000:02:06.0 > 02:06.0 Ethernet controller: Intel Corporation 82546GB Gigabit > Ethernet Controller (rev 03) > Subsystem: Intel Corporation PRO/1000 MT Dual Port Network > Connection > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- > ParErr- Stepping- SERR- FastB2B- > Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >>TAbort- <TAbort- <MAbort- >SERR- <PERR- > Latency: 32 (63750ns min), Cache Line Size 08 > Interrupt: pin A routed to IRQ 177 > Region 0: Memory at d0000000 (64-bit, non-prefetchable) > [size=128K] > Region 4: I/O ports at c000 [size=64] > Capabilities: [dc] Power Management version 2 > Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA > PME(D0+,D1-,D2-,D3hot+,D3cold+) > Status: D0 PME-Enable- DSel=0 DScale=1 PME- > Capabilities: [e4] PCI-X non-bridge device > Command: DPERE- ERO > [17:39:55] byte_0xEB_0xFE: + RBC=512 OST=1 > Status: Dev=02:06.0 64bit+ 133MHz+ SCD- USC- DC=simple > DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- > Capabilities: [f0] Message Signalled Interrupts: 64bit+ > Queue=0/0 Enable- > Address: 0000000000000000 Data: 0000 > > > Settings for eth2: > Supported ports: [ TP ] > Supported link modes: 10baseT/Half 10baseT/Full > 100baseT/Half 100baseT/Full > 1000baseT/Full > Supports auto-negotiation: Yes > Advertised link modes: 10baseT/Half 10baseT/Full > 100baseT/Half 100baseT/Full > 1000baseT/Full > Advertised auto-negotiation: Yes > Speed: 1000Mb/s > Duplex: Full > Port: Twisted Pair > PHYAD: 1 > Transceiver: internal > Auto-negotiation: on > Supports Wake-on: umbg > Wake-on: g > Current message level: 0x00000007 (7) > Link detected: yes > > Offset Values > ------ ------ > 0x0000 00 e0 81 5a f7 86 30 08 ff ff ff ff ff ff ff ff > 0x0010 14 c4 03 21 0b 46 79 11 86 80 79 10 86 80 e8 b4 > 0x0020 0c 00 7a 10 00 00 05 03 cc 1e ff ff ff ff ff ff > 0x0030 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > 0x0040 0c c3 63 ff 04 50 05 03 c8 0c ff ff ff > [17:39:57] byte_0xEB_0xFE: ff ff ff > 0x0050 ff ff ff ff ff ff ff ff ff ff ff ff ff ff 02 06 > 0x0060 00 01 00 40 11 12 ff ff ff ff ff ff ff ff ff ff > 0x0070 ff ff ff ff ff ff ff ff ff ff ff ff ff ff 85 40 > > CPU0 CPU1 > 0: 614377 0 IO-APIC-edge timer > 1: 388 0 IO-APIC-edge i8042 > 4: 1272 0 IO-APIC-edge serial > 9: 0 0 IO-APIC-level acpi > 169: 17752 0 IO-APIC-level eth1 > 177: 137808 0 IO-APIC-level libata, eth2 > 201: 25860 0 IO-APIC-level eth0 > NMI: 0 0 > LOC: 614176 614269 > ERR: 0 > MIS: 0 > > > > -- > Best regards, > Stanislav Bogatyrev aka realloc() > > ------------------------------------------------------------------------ > - > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > E1000-devel mailing list > E1000-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/e1000-devel > -- Best regards, Stanislav Bogatyrev aka realloc() ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel
