This command will reset the interface. I bet the same effect can be achieved with ethtool -r eth0
Have you tried ifconfig eth0 down/up? Looks like an interface reset "resolves" the issue. Thanks, Emil -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ronciak, John Sent: Wednesday, May 21, 2008 11:24 AM To: Stanislav Bogatyrev Cc: e1000-devel@lists.sourceforge.net Subject: Re: [E1000-devel] e1000 freezing during boot ethtool was already reporting the interface to be twisted pair (tp) from your other email. So the command should not be doing anything. What made you try this? Cheers, John ----------------------------------------------------------- "Those who would give up essential Liberty, to purchase a little temporary Safety, deserve neither Liberty nor Safety.", Benjamin Franklin 1755 -----Original Message----- From: Stanislav Bogatyrev [mailto:[EMAIL PROTECTED] Sent: Wednesday, May 21, 2008 11:07 AM To: Ronciak, John Cc: e1000-devel@lists.sourceforge.net Subject: Re: [E1000-devel] e1000 freezing during boot Hello, Also, when eth2 is in freeze state, running `ethtool -s eth2 port tp` solves the problem. On Wed, May 21, 2008 at 7:13 PM, Ronciak, John <[EMAIL PROTECTED]> wrote: > Does the driver that comes with SLES10 work? Does eth0 or eth1 work? > > What is the output from: > ethtool <ethx> > ethtool -i <ethx> > netstate -i > ifconfig ethx > > > Cheers, > John > ----------------------------------------------------------- > "Those who would give up essential Liberty, to purchase a little > temporary Safety, deserve neither Liberty nor Safety.", Benjamin > Franklin 1755 > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of > Stanislav Bogatyrev > Sent: Wednesday, May 21, 2008 6:52 AM > To: e1000-devel@lists.sourceforge.net > Subject: [E1000-devel] e1000 freezing during boot > > Hello, All! > > I run SLES-10 Linux with kernel 2.6.16. When system boots up. It > configures network interfaces, but stays unreachable. When pingning > from a remote - we just don't get ARP reply. When pinging from > computer with the problem we see arp requests and arp replies (tcpdump > on the target), but those replies do not come to OS level. Compilation > with MSI disabled or with NAPI disabled doesn't solve the issue. > > Is there any workaround for this issue? > > kernel: 2.6.16-SLES10 > driver: e1000 > version: 7.6.15.5 > firmware-version: N/A > bus-info: 0000:02:06.0 > 02:06.0 Ethernet controller: Intel Corporation 82546GB Gigabit > Ethernet Controller (rev 03) > Subsystem: Intel Corporation PRO/1000 MT Dual Port Network > Connection > Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- > ParErr- Stepping- SERR- FastB2B- > Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >>TAbort- <TAbort- <MAbort- >SERR- <PERR- > Latency: 32 (63750ns min), Cache Line Size 08 > Interrupt: pin A routed to IRQ 177 > Region 0: Memory at d0000000 (64-bit, non-prefetchable) > [size=128K] > Region 4: I/O ports at c000 [size=64] > Capabilities: [dc] Power Management version 2 > Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA > PME(D0+,D1-,D2-,D3hot+,D3cold+) > Status: D0 PME-Enable- DSel=0 DScale=1 PME- > Capabilities: [e4] PCI-X non-bridge device > Command: DPERE- ERO > [17:39:55] byte_0xEB_0xFE: + RBC=512 OST=1 > Status: Dev=02:06.0 64bit+ 133MHz+ SCD- USC- DC=simple > DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- > Capabilities: [f0] Message Signalled Interrupts: 64bit+ > Queue=0/0 Enable- > Address: 0000000000000000 Data: 0000 > > > Settings for eth2: > Supported ports: [ TP ] > Supported link modes: 10baseT/Half 10baseT/Full > 100baseT/Half 100baseT/Full > 1000baseT/Full > Supports auto-negotiation: Yes > Advertised link modes: 10baseT/Half 10baseT/Full > 100baseT/Half 100baseT/Full > 1000baseT/Full > Advertised auto-negotiation: Yes > Speed: 1000Mb/s > Duplex: Full > Port: Twisted Pair > PHYAD: 1 > Transceiver: internal > Auto-negotiation: on > Supports Wake-on: umbg > Wake-on: g > Current message level: 0x00000007 (7) > Link detected: yes > > Offset Values > ------ ------ > 0x0000 00 e0 81 5a f7 86 30 08 ff ff ff ff ff ff ff ff > 0x0010 14 c4 03 21 0b 46 79 11 86 80 79 10 86 80 e8 b4 > 0x0020 0c 00 7a 10 00 00 05 03 cc 1e ff ff ff ff ff ff > 0x0030 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > 0x0040 0c c3 63 ff 04 50 05 03 c8 0c ff ff ff > [17:39:57] byte_0xEB_0xFE: ff ff ff > 0x0050 ff ff ff ff ff ff ff ff ff ff ff ff ff ff 02 06 > 0x0060 00 01 00 40 11 12 ff ff ff ff ff ff ff ff ff ff > 0x0070 ff ff ff ff ff ff ff ff ff ff ff ff ff ff 85 40 > > CPU0 CPU1 > 0: 614377 0 IO-APIC-edge timer > 1: 388 0 IO-APIC-edge i8042 > 4: 1272 0 IO-APIC-edge serial > 9: 0 0 IO-APIC-level acpi > 169: 17752 0 IO-APIC-level eth1 > 177: 137808 0 IO-APIC-level libata, eth2 > 201: 25860 0 IO-APIC-level eth0 > NMI: 0 0 > LOC: 614176 614269 > ERR: 0 > MIS: 0 > > > > -- > Best regards, > Stanislav Bogatyrev aka realloc() > > ------------------------------------------------------------------------ > - > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > E1000-devel mailing list > E1000-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/e1000-devel > -- Best regards, Stanislav Bogatyrev aka realloc() ------------------------------------------------------------------------ - This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel
