>-----Original Message----- >From: Kevin Wilson [mailto:wkev...@gmail.com] >Sent: Thursday, September 15, 2016 11:18 AM >To: e1000-devel@lists.sourceforge.net >Subject: [E1000-devel] Setting speed of ixgbe to be 1000 > >Hello, >I have an IXGBE connected by a direct attach cable to a 3com 1GB switch >port. >I try to set the speed to be 1000 in the following ways, and fail in >all of them. > >Any ideas how can I achieve this ? > >ethtool -s eth3 speed 1000 duplex full autoneg off >Cannot set new settings: Invalid argument > not setting speed > not setting duplex > not setting autoneg > >Also ethtool -s eth3 speed 1000 gave an error; > > ethtool -s eth3 speed 1000 >Cannot set new settings: Invalid argument > not setting speed > > >ethtool -s eth3 advertise 0x020 >Cannot set new settings: Invalid argument
Can you provide the output of `ethtool eth3`? The driver will not allow setting speed that is not supported by the interface. Thanks, Emil ------------------------------------------------------------------------------ _______________________________________________ E1000-devel mailing list E1000-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/e1000-devel To learn more about Intel® Ethernet, visit http://communities.intel.com/community/wired
