Try:

Ethtool -s eth3 advertise 0x20

Thanks,
-Don <donald.c.skidm...@intel.com>


> -----Original Message-----
> From: Kevin Wilson [mailto:wkev...@gmail.com]
> Sent: Thursday, September 15, 2016 11:18 AM
> To: e1000-devel@lists.sourceforge.net
> Subject: [E1000-devel] Setting speed of ixgbe to be 1000
> 
> Hello,
> I have an IXGBE connected by a direct attach cable to a 3com 1GB switch port.
> I try to set the speed to be 1000 in the following ways, and fail in all of 
> them.
> 
> Any ideas how can I achieve this ?
> 
> ethtool -s eth3 speed 1000 duplex full autoneg off Cannot set new settings:
> Invalid argument
>   not setting speed
>   not setting duplex
>   not setting autoneg
> 
> Also ethtool -s eth3 speed 1000  gave an error;
> 
>  ethtool -s eth3 speed 1000
> Cannot set new settings: Invalid argument
>   not setting speed
> 
> 
> ethtool -s eth3 advertise 0x020
> Cannot set new settings: Invalid argument
> 
> Regards,
> Kevin
> 
> ------------------------------------------------------------------------------
> _______________________________________________
> E1000-devel mailing list
> E1000-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/e1000-devel
> To learn more about Intel&#174; Ethernet, visit
> http://communities.intel.com/community/wired

------------------------------------------------------------------------------
_______________________________________________
E1000-devel mailing list
E1000-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/e1000-devel
To learn more about Intel&#174; Ethernet, visit 
http://communities.intel.com/community/wired

Reply via email to