Hi,
EB debug log unfortunately says nothing about the problem. I have
already provided a batch accounting log
to GC3Pie, however that did not change anything. Does GC3Pie have any
debug options, so that
details on the connection to batch system is logged ? At least for
GC3Pie config file I could not find any.
I will provide EB & GC3Pie logs.
Thank you,
Gizo
Quoting Riccardo Murri <[email protected]>:
Hello,
submitting job with --job option prints a failure message, though a
software installation is successfully finished. A job is successfully
completed from the resource manager, torque, point of view as well
(exit status 0).
The job backend is GC3Pie/2.4.2 and the resource manager used is torque
Typically this means that GC3Pie was not able to reap the exit status
from the batch system (`tracejob` is used on TORQUE and `qsub -x` is
used on PBSPro). Can you please re-run with DEBUG output and send the
full log? That should contain some indication about what failed.
Ciao,
R
--
Riccardo Murri
http://www.s3it.uzh.ch/about/team/#Riccardo.Murri
S3IT: Services and Support for Science IT
University of Zurich
Winterthurerstrasse 190, CH-8057 Zürich (Switzerland)
Tel: +41 44 635 4208
Fax: +41 44 635 6888
--
Dr. Gizo Nanava
Leibniz Universitaet IT Services
Leibniz Universitaet Hannover
Schlosswender Str. 5
D-30159 Hannover
Tel +49 511 762 7919085
http://www.luis.uni-hannover.de
