On 26/05/16 17:47, Riccardo Murri wrote:
Hello,
submitting job with --job option prints a failure message, though a
software installation is successfully finished. A job is successfully
completed from the resource manager, torque, point of view as well
(exit status 0).
The job backend is GC3Pie/2.4.2 and the resource manager used is torque
Typically this means that GC3Pie was not able to reap the exit status
from the batch system (`tracejob` is used on TORQUE and `qsub -x` is
used on PBSPro). Can you please re-run with DEBUG output and send the
full log? That should contain some indication about what failed.
Riccardo, are you sure about tracejob with Torque?
Our users don't have access to tracejob, yet GC3Pie works just fine...
regards,
Kenneth
Ciao,
R
--
Riccardo Murri
http://www.s3it.uzh.ch/about/team/#Riccardo.Murri
S3IT: Services and Support for Science IT
University of Zurich
Winterthurerstrasse 190, CH-8057 Zürich (Switzerland)
Tel: +41 44 635 4208
Fax: +41 44 635 6888
