I'll try to push it into a PR today. On 02/06/2018 12:05 PM, Balázs Hajgató wrote: > Dear Espen, > > Is ti possible to get the working solution for Dalton? > > Sincerely, > > Balazs > > > On 26/01/2018 23:01, Espen Tangen wrote: >> Read you load and clear, Jack. Do base our Dalton config on >> CMakeMake.block, finally made it work. Actually, the Dalton people >> found some issues in the process. >> >> Regards >> >> Et. >> >> [email protected] på vegne av Jack Perdue >> <[email protected] på vegne av [email protected]> skrev >> følgende den 25.01.2018, 14:57: >> >> The only 2 easyblocks anyone needs are ConfigureMake and CMakeMake >> All the rest are to hide stuff in python so that when the install >> process >> changes in a few years nobody can fix if but EB warriors. >> :) >> jack (not a big fand of a lot of easyblocks) >> On 01/25/2018 06:53 AM, Espen Tangen wrote: >> > >> > Hi all. I have started on an attempt to make a Dalton install >> > procedure for EB. Currently I have been focusing on an easyconfig. >> > >> > Is there a clever way to alter DCMAKE_Fortran_COMPILER in >> easyconfig >> > so that the CMake setup reads it correctly at configure? >> > >> > Or will I have to start making an easyblock too? >> > >> > Regards >> > >> > Et. >> > >> > PS: Don´t worry, this time I will do PR to devel. >> > >> >
-- Ake Sandgren, HPC2N, Umea University, S-90187 Umea, Sweden Internet: [email protected] Phone: +46 90 7866134 Fax: +46 90-580 14 Mobile: +46 70 7716134 WWW: http://www.hpc2n.umu.se
