Dear Åke,
You just left out the most important things: the patches.
Sincerely,
Balazs
On 06/02/2018 12:34, Åke Sandgren wrote:
PR https://github.com/easybuilders/easybuild-easyconfigs/pull/5778
That's the one we have installed here.
On 02/06/2018 12:05 PM, Balázs Hajgató wrote:
Dear Espen,
Is ti possible to get the working solution for Dalton?
Sincerely,
Balazs
On 26/01/2018 23:01, Espen Tangen wrote:
Read you load and clear, Jack. Do base our Dalton config on
CMakeMake.block, finally made it work. Actually, the Dalton people
found some issues in the process.
Regards
Et.
[email protected] på vegne av Jack Perdue
<[email protected] på vegne av [email protected]> skrev
følgende den 25.01.2018, 14:57:
The only 2 easyblocks anyone needs are ConfigureMake and CMakeMake
All the rest are to hide stuff in python so that when the install
process
changes in a few years nobody can fix if but EB warriors.
:)
jack (not a big fand of a lot of easyblocks)
On 01/25/2018 06:53 AM, Espen Tangen wrote:
>
> Hi all. I have started on an attempt to make a Dalton install
> procedure for EB. Currently I have been focusing on an easyconfig.
>
> Is there a clever way to alter DCMAKE_Fortran_COMPILER in
easyconfig
> so that the CMake setup reads it correctly at configure?
>
> Or will I have to start making an easyblock too?
>
> Regards
>
> Et.
>
> PS: Don´t worry, this time I will do PR to devel.
>
--
HPC consultant
HPC/VSC Support and System Administration
Computing Center
ULB/VUB
Avenue Adolphe Buyllaan 91 - CP 197
1050 Brussels
Belgium
