-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gary Thomas Sent: Donnerstag, 1. November 2007 12:49 To: EXTERNAL Gladis Olaf (Praktikant; CR/AEM) Cc: [email protected] Subject: Re: [ECOS] Can't connect properly (TCP/IP)
>> [cyg_net_init] Init: call_route_init(0x00000000) >> [cyg_net_init] Done >> [eth_drv_ioctl] Warning: Driver can't set multi-cast mode >> [eth_drv_ioctl] Warning: Driver can't set multi-cast mode >> [eth_drv_ioctl] Warning: Driver can't set multi-cast mode >> skTPI_Init: FPGA loaded with file /FPGA_Default.rbf >> VERSION: 0x101D and >> $T04thread:00000006;40:001647c0;01:00164788;#41+ > >These messages indicate that your program has crashed (at PC=0x1647c0) >Try connecting with GDB to find out why. > Thank You. The last time I could step through the code until the connect statement. After that my server printed the message that the node hast successfully connected, but the debugger hang up. After 5 to 10 minutes the node restarted again, but the debugger printed status "running". And the console printed after every time I hit the enter key, something like "GDB Device busy". Do you, or anybody else know, how to find out why it crashed (at this place)? Best regards, and much thanks in advance. Olaf Gladis >-- >------------------------------------------------------------ >Gary Thomas | Consulting for the >MLB Associates | Embedded world >------------------------------------------------------------ > >-- >Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos >and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss > > -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
