[email protected] wrote: > Thanks Eugen, > I just sent another message to the list on this subject. > I suspect there is no simple way to run gconf on windows. > I even don't know how to run ekiga -d4 on windows, maybe my friend should use > the DOS prompt and type > ekiga -d4 > or > ekiga /d4.
This is at http://wiki.ekiga.org/index.php/Debugging_Ekiga#How_to_get_a_debug_output_2 Eugen > My friend was able do an almost satisfactory setup of X-lite but he had to > specify the stun server to be used, which is not possible with Ekiga. > Thanks again for your advice anyway. > > Best regards, > > Antonio > > > On Thu, 17 Dec 2009 12:37:31 +0100 > Eugen Dedu <[email protected]> wrote: > >> [email protected] wrote: >>> A friend of mine is trying to configure Ekiga 3.2.6 under Windows XP. He is >>> not able to find neither the "NAT test" nor the stun server setup section >>> in the configuration menus. >>> Could somebody clarify what is the correct procedure for this type of >>> configuration? >> Hi, >> >> NAT test is automatically performed each time ekiga is started (see >> ekiga -d 4 for ex.) >> >> You can change the nat server in gconf settings (general/nat section), >> but I do not know on windows ekiga where gconf settings are stored. >> >> -- >> Eugen >> _______________________________________________ >> ekiga-list mailing list >> [email protected] >> http://mail.gnome.org/mailman/listinfo/ekiga-list > > _______________________________________________ ekiga-list mailing list [email protected] http://mail.gnome.org/mailman/listinfo/ekiga-list
