Thanks Anatolij. Prior to your email, I found this site
ftp://ftp.denx.de/pub/u-boot/images/amcc/canyonlands/ and downloaded the u-boot.bin-1.3.3 and followed the instructions in section 5.4.3 from http://www.denx.de/wiki/publish/DULG/DULG-canyonlands.pdf When I type reset at the very end, my xminicom just hung. Additionally when I power cycle the EP440xS board, no output goes to the xminicom. It seems the u-boot update hosed up the board. Any ideas on how to reset the factory settings? Thanks...Jim -----Original Message----- From: Anatolij Gustschin [mailto:[email protected]] Sent: Tuesday, November 23, 2010 2:49 PM To: Snyder, James (jsnyde07) Cc: [email protected] Subject: Re: [ELDK] make canyonlands_config Hello Jim, On Tue, 23 Nov 2010 14:14:09 -0500 "Snyder, James (jsnyde07)" <[email protected]> wrote: > Hello, > > In the file > > http://www.denx.de/wiki/publish/DULG/DULG-canyonlands.pdf > > on page 38 at the bottom, section 5.3, if I cd into the u-boot directory > I can do the "make distclean". However when I try "make > canyonlands_config" I get the > make: *** No rule to make target `canyonlands'. Stop > > Any input would be of great help. Unfortunately the canyonlands board support is not available in the old U-Boot version 1.3.2. Please try to use more recent U-Boot version, e.g. the version v2010.09. You can also get it from the ftp server: $ wget ftp://ftp.denx.de/pub/u-boot/u-boot-2010.09.tar.bz2 $ tar xjf u-boot-2010.09.tar.bz2 $ ln -s u-boot-2010.09 u-boot $ cd u-boot $ make distclean $ make canyonlands_config $ make all Best regards, Anatolij -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [email protected] _______________________________________________ eldk mailing list [email protected] http://lists.denx.de/mailman/listinfo/eldk
