Thanks Wolfgang for the feedback.
However it looked like I was having some good luck yesterday up until I
flashed a new u-boot. This is the startup output once I got Chapter 6
correctly done and Chapter 7 correctly done. Note the "Created:"
date/time which is inline with when I made the denx linux image.
Additionally I could do an iminfo on the memory location of the linux
distro and it came back with valid output (that I could tell). When I
did the iminfo command on the memory location on the tree blob it stated
"Bad Magic Number".
With the output below do you think it still isn't supported? It looks
like I was getting close.
Thanks...Jim
U-Boot 1.1.6 (Aug 25 2010 - 16:37:50)
CPU: AMCC PowerPC 440EPx Rev. A at 533.333 MHz (PLB=133, OPB=66,
EBC=66 MHz)
Security/Kasumi support
I2C boot EEPROM enabled
Bootstrap Option G - Boot ROM Location I2C (Addr 0x54)
32 kB I-Cache 32 kB D-Cache
Board: Embedded Planet EP440xS, serial# 70274
I2C: ready
DRAM: 256 MB
FLASH: 64 MB
NAND: 512 MiB
In: serial
Out: serial
Err: serial
USB: Host(int phy) Device(ext phy)
Net: ppc_4xx_eth0, ppc_4xx_eth1
Type run flash_nfs to mount root filesystem over NFS
Hit any key to stop autoboot: 0
## Booting image at ff000000 ...
Image Name: Linux-2.6.37-rc1
Created: 2010-11-23 14:54:10 UTC
Image Type: PowerPC Linux Kernel Image (gzip compressed)
Data Size: 1551046 Bytes = 1.5 MB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
## Loading RAMDisk Image at 00000000 ...
Bad Magic Number
-----Original Message-----
From: Wolfgang Denk [mailto:[email protected]]
Sent: Tuesday, November 23, 2010 5:57 PM
To: Snyder, James (jsnyde07)
Cc: [email protected]
Subject: Re: [ELDK] make canyonlands_config
Dear James,
In message
<[email protected]> you
wrote:
>
> My co-worker always mentioned canyonland.
>
> The board we have is
> http://www.embeddedplanet.com/assets/Uploads/DataSheetEP440xS.pdf
>
> How would I tell by the look of it if it is the sequoia board or not?
This is neither one nor the other. It has the same processor (440EPx)
as the Sequoia board, but looks completely different.
This board appears not to be supported by mainline U-Boot nor Linux.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected]
Clothes make the man. Naked people have little or no influence on
society. - Mark Twain
_______________________________________________
eldk mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/eldk
