ya, maybe my mktemp version is too old:
mktemp -V
mktemp version 1.5
but i have installed EDLK-5.2.1,just like this : "tmp_dir=$(mktemp -d
--tmpdir=${inst_path} eldk_install.XXXXX) "→ →
change to be "tmp_dir=$(mktemp -d ${inst_path}/eldk_install.XXXXX) "
because i'm brand new to embeded linux developer, special with ELDK. How can i
know it is installed successfully, and set environment variables for
powerpc-e500v2 (ppc P2020 in freescale). and uh, how to use ELDK for developing
U-Boot.
thank you very much
best regards.
在 2012-09-27 15:39:54，"Wolfgang Denk" <[email protected]> 写道：
>Dear 汪政,
>
>In message
><cab+gdsy1b4xa9bwrrtcdaohl75ojnsz8x7dt4e298dtff17...@mail.gmail.com> you wrote:
>>
>> during the installation of ELDK-5.2.1, I get into troubles as
>> following , ofcourse, i guaranty that all files are coming from denx, and
>> their sha256sums are correct.
>> executing "./install.sh -s gmae -r "minimal-dev sato-sdk" powerpc-e500v2"
>> prompting messages: "mktemp invalid option", then i check "install.sh",
>> find "mktemp" command used not properly just like "mktemp -d
>> --tmpdir=3D${inst_path} eldk_install.XXXXX--" , which according to "man
>> mktemp" shoul be "mktemp -d -p=3D$...."
>
>As Stefano already wrote, this probably means that you are using a
>pretty old version of mktemp. Could you please be so kind and let me
>know what your exact build environment is, i. e. send at least the
>output of the following commands:
>
> $ mktemp -V
> $ cat /etc/issue
>
>Thanks in advance.
>
>Best regards,
>
>Wolfgang Denk
>
>--
>DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
>HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
>Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected]
>Fascinating, a totally parochial attitude.
> -- Spock, "Metamorphosis", stardate 3219.8
_______________________________________________
eldk mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/eldk
