ya, maybe my mktemp version is too old:
mktemp -V
mktemp version 1.5
but i have installed EDLK-5.2.1,just like this : "tmp_dir=$(mktemp -d
--tmpdir=${inst_path} eldk_install.XXXXX) "→ →
change to be "tmp_dir=$(mktemp -d ${inst_path}/eldk_install.XXXXX) "
because i'm brand new to embeded linux developer, special with ELDK. How can i
know it is installed successfully, and set environment variables for
powerpc-e500v2 (ppc P2020 in freescale). and uh, how to use ELDK for developing
U-Boot.
thank you very much
best regards.
在 2012-09-27 15:26:52，"Stefano Babic" <[email protected]> 写道：
>On 27/09/2012 05:39, 汪政 wrote:
>> Dear:
>> during the installation of ELDK-5.2.1, I get into troubles as
>> following , ofcourse, i guaranty that all files are coming from denx, and
>> their sha256sums are correct.
>> executing "./install.sh -s gmae -r "minimal-dev sato-sdk" powerpc-e500v2"
>> prompting messages: "mktemp invalid option", then i check "install.sh",
>> find "mktemp" command used not properly just like "mktemp -d
>> --tmpdir=${inst_path} eldk_install.XXXXX--" , which according to "man
>> mktemp" shoul be "mktemp -d -p=$...."
>>
>> but after i changed according to that, prompt the message " cannot make
>> tempdir eldk_install.xxxxx"
>>
>>
>> how can i solve the problems?
>
>There was already a thread about this, check for example:
> http://www.mail-archive.com/[email protected]/msg00572.html
>
>It seems the same case and that mktemp on your distro is too old.
>
>Best regards,
>Stefano Babic
>
>--
>=====================================================================
>DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
>HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
>Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: [email protected]
>=====================================================================
_______________________________________________
eldk mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/eldk
