Dear Fabio Estevam,
On 16.11.2013 13:47, schrieb Fabio Estevam:
Shouldn't this be ttyAMA0 instead?
On my evaluation board i'm using the UART3. When using ttyAMA0 theres no
output after U-boot "Starting kernel ..."
Starting Bootlog daemon: bootlogd: cannot find console device 249:3 under
According to this message the console device was not found.
So it seems you need to pass ttyAMA0 in your kernel command line.
I can't use the UART0 on my evaluation board. I don't understand why
this should cause the hang, because the output is already done at ttyAPP3?!
Best regards,
Tobias Markow
_______________________________________________
eldk mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/eldk
