On Sat, Nov 16, 2013 at 11:11 AM, Fabio Estevam <[email protected]> wrote: > On Sat, Nov 16, 2013 at 11:06 AM, Tobias Markow > <[email protected]> wrote: > >> I can't use the UART0 on my evaluation board. I don't understand why this >> should cause the hang, because the output is already done at ttyAPP3?! > > Ok, understood. > > Please check if your /etc/inittab is pointing to ttyAMA0. If so, then > please change it to ttyAPP3.
Or just change the SERIAL_CONSOLE in your board .conf to point to the correct ttyAPP3 port. Regards, Fabio Estevam _______________________________________________ eldk mailing list [email protected] http://lists.denx.de/mailman/listinfo/eldk
