On Jul 19, 2004, at 5:59 PM, Pauli Nunez EA3BLQ wrote:
Any new ideas will be more than welcome. Best wishes for good luck to
you
all.
I had a persistant, intermittant INFO 080 message that I finally traced
down to a bit of slightly conductive solder flux between the two pins
of the AF Filter board terminals. It was pulling the AUXBUS toward +8
volts.
I'd start by checking the voltages on the AUXBUS with and without the
KPA100 attached. The AUXBUS ought to read 5 volts when nothing is
happening. If you have a scope, you can watch the AUXBUS go low as the
various microprocessors try to talk to one another.
Bill Coleman, AA4LR, PP-ASEL Mail: [EMAIL PROTECTED]
Quote: "Not within a thousand years will man ever fly!"
-- Wilbur Wright, 1901
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
