You can loop the audio back to the output in CWGet. Unfortunately, the time delay on my computer is significant. I was unable to send CW because of the delay.
You need to split the audio before it goes into the computer. A simple y-connector works. Jeff Burns AD9T -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of James T. "Jim" Rogers Sent: Tuesday, July 27, 2004 7:25 AM To: Elecraft Reflector Subject: [Elecraft] OK Computer gurus, a little help Is there a way to have the audio input (say K2 audio) to the sound card "loop back" to the output. In other words if I patch the audio from the K2 to the sound card input to use CWGet, I would like to use the audio output from the sound card to monitor the cw audio. The documentation on the sound card in my hp zu1175 seems a bit sketchy, and no doubt this may be something most people do not want to do. Hey if that isn't clear, give me a break, I am, after all, sound card challenged.... Thanks and 73, Jim W4ATK K2/100 4028 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
