Gary,
Is the RF gain control fully advanced? - it should have been when you set
the AGC Threshold for 3.80 volts.
Have you set S-Lo and S-Hi values after setting the AGC threshold?
Did you restore the RF gain to the full clockwise position after setting
S-HI?
Any of the above would cause the rightmost LED to be on.
73,
Don W3FPR
----- Original Message -----
I'm not sure whether this is a problem or not but after performing the
S-meter alignment on p. 47 of the K2 assembly manaual, the tenth bargraph
LED stays lit. It is lit whenever I turn on the rig. The AGC threshold is
3.80 Vdc at U2 pin5. I have completed Alignment and Test II with no
problems or defects.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
